Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 531)

100

101

Central Site Remote Access Switch 531

YSTEM

ESSAGES

System Message Summary

SSB: Post 32 i960hdlc_1 FAILURE

The i960 failed its 80532 test using the first HDLC controller. The boot process should continue;

however, make note of the error message in the event of a future problem.

SSB: Post 33 i960hdlc_2 FAILURE

The i960 failed its 80532 test using the second HDLC controller. The boot process should continue;

however, make note of the error message in the event of a future problem.

SSB: Post 34 i960hdlc_3 FAILURE

The i960 failed its 80532 test using the third HDLC controller. The boot process should continue;

however, make note of the error message in the event of a future problem.

SSB: Post 35 i960hdlc_4 FAILURE

The i960 failed its 80532 test using the fourth HDLC controller. The boot process should continue;

however, make note of the error message in the event of a future problem.

SSB: Post 36 i960isdn_1 FAILURE

SSB: Post 37 i960isdn_2 FAILURE

SSB: Post 38 i960isdn_3 FAILURE

SSB: Post 39 i960isdn_4 FAILURE

The i960 failed its 2086 test using the first (second, third or fourth) D-channel controller The boot

process should continue; however, make note of the error message in the event of a future problem.

SSB: Timed out waiting for i960 to initialize for POSTSs

The i960 did not respond to an initialization request in a timely manner. This is a i960 failure. The

boot process should continue; however, make note of the error message in the event of a future

problem.

Starting Triggered RIP/SAP for <device>

This message indicates that triggered RIP/SAP has started for a device (either locally configured

or one present in the WAN peer list). Triggered RIP/SAP has been configured as a routing protocol

for this particular device.

Stream Ready rejected - MTU too small

The remote device will only accept the stream connection if the MTU is set to be >

1514. Check to

make sure that the remote device and the CyberSWITCH MTU value is set to >

1514.

[STP] A BLAN Topology Change has been detected

The system has detected a topology change in the Spanning Tree environment.

[STP] A new Root Bridge has been detected

The system has detected a new root bridge for the Spanning Tree environment.

[STP] LAN Port <port #> is now a Designated Port

The indicated LAN port has become the designated port for the attached LAN.

[STP] LAN Port <port #> is now the Root Port

The indicated LAN port has become the root port for the system.

[STP] This Bridge is now the Root Bridge

The system has become the root bridge for the Spanning Tree environment.

1 2 ... 526 527 528 529 530 531 532 533 534 535 536 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 531

Commentaires sur ces manuels