Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 522)

100

101

USER’S GUIDE

522 CyberSWITCH

Out Svc # <slot #, port #>

ISDN line failure. The line connected to the indicated slot and port is out of service for the reason

indicated by #.

1 = No layer 1 sync for 5 seconds

This problem normally occurs due to WAN cabling problems.

Check your cables to make sure they are connected correctly. If this problem still occurs

after you have checked all the cables, call the phone company and report the problem.

2 = No response to TEI requests

This problem normally occurs due to invalid configuration.

Check your configuration using the following table:

3 = No UA response to SABME requests; no Layer 2

This problem normally occurs due to invalid configuration.

Check your configuration using the previous table.

4 = Failure to negotiate SPID (U.S. only). This is due to an improperly configured SPID. Check

your configuration.

5 = Failure to negotiate SPID (U.S. only). SPID has not been configured on the system; check

configuration.

Over Max Charge

Monthly call charges exceeded. Monthly call charge tracking is enabled and the configured

maximum has been exceeded.

[PAP] Identification timeout on remote device

The remote device did not send the PAP Authenticate-Request packet within a required amount of

time. Try again. If this persists, contact your remote site.

[PAP] Invalid password for <name> given by remote device

The system received the PAP Authentication-Request packet with the incorrect password for the

device name <name>.

[PAP] Remote device did not respond to the request

The system sent PAP Authenticate-Request packets the maximum number of times, but the remote

device did not send either Authenticate-Ack or Authenticate-Nak packets. The remote device may

basic rate line from phone co:

point-to-point

line from phone co:

multi-point

line configured on non-

auto TEI

make sure that the

configured TEI value

is 0

change TEI to be

AUTO

line configured on auto

TEI

change TEI to be non-

auto

if problem happens

for over 5 minutes,

report problem to

phone company

1 2 ... 517 518 519 520 521 522 523 524 525 526 527 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 522

Commentaires sur ces manuels