Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 515)

100

101

Central Site Remote Access Switch 515

YSTEM

ESSAGES

System Message Summary

LAN Adapter Command Timeout

The system expected a command from the LAN adapter or subsystem that it did not receive. Check

for proper LAN adapter configuration and hardware installation. If it persists, report the event

using the problem reporting form included in Getting Assistance.

LAN Adapter configuration conflict

There is a configuration conflict between the Ethernet resource that was installed and the Ethernet

resource that was configured. Correct the configuration to match the installation.

LAN Adapter Fatal Error Reported

LAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.

LAN Adapter FIFO Data Underrun

The system expected data from the adapter that it did not receive, and the system will continue to

operate. Check for proper LAN adapter configuration and hardware installation.

LAN Adapter FIFO not empty, status=<status value>

The LAN adapter did not enter the proper state after it was restarted. Check for proper LAN

adapter configuration and hardware installation.

LAN Adapter HW upgrade may be required

Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the

above message appears in your system log messages, you will need to remove your Ethernet

adapter to determine if it is a version that needs to be updated. Refer to the “Notes and Warnings”

section of the Release Notes for further instructions.

LAN Adapter HW upgrade required

Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the

above message appears in your system log messages, you will need to upgrade your Ethernet

adapter.

LAN Adapter LAN Controller error

The system detected an error with the LAN controller. The LAN adapter card may be faulty.

Contact your Distributor or Customer Support.

LAN Adapter not configured

The system tried to access the bridging function when it was not configured. Most likely, the

Ethernet resource was accidentally deleted. Correct the system configuration to reflect the proper

Ethernet resource.

LAN Adapter out of receive buffers for LAN port <port #>

The LAN adapter is temporarily out of receive buffers for the indicated port. This condition should

clear itself. If the condition persists, contact your Distributor or Customer Support.

LAN Adapter out of receive buffers for the WAN port

The LAN adapter is temporarily out of the buffers it uses to receive packets from the WAN port.

This condition should clear itself. If the condition persists, contact your Distributor or Customer

Support.

LAN Adapter port <port #> transmit error <error code>, check connection

The LAN adapter detected an error transmitting a frame on the indicated port. Check that the LAN

is properly connected to the adapter and that the LAN is properly terminated.

1 2 ... 510 511 512 513 514 515 516 517 518 519 520 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 515

Commentaires sur ces manuels