Enterasys Networks CSX7000 Manuel d'utilisateur Page 508

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 507
USER’S GUIDE
508 CyberSWITCH
Invalid return code from SIG_get_rsc_inbound
Invalid return code from SIG_get_rsc_outbound
An error has been detected in the R2 signaling procedure, and will typically result in a failed call.
The error was due to unrecognizable or incorrect information. If problem persists, contact your
Distributor or Customer Support.
Invalid SERIAL.001 file present, file is ignored.
Contact your Distributor or Customer Support.
Invalid SERIAL.BIN file present, system booting in minimal mode.
Contact your Distributor or Customer Support.
Invalid serial number in SERIAL.001, file is ignored.
Contact your Distributor or Customer Support.
Invalid serial number in SERIAL.BIN file, system booting in minimal mode.
Contact your Distributor or Customer Support.
IP Error from ESP datagram - discarded
An error occurred within the IP forwarding logic which make it impossible to send this datagram.
[IP] Invalid Device Info. Device is not IP callable <device name>
An IP packet could not be forwarded to a remote network because the next-hop device for that
network is not configured as IP Callable. The CyberSWITCH returns a network unreachable message
to the sender.
[IP] x.x.x.x not added to the pool: Invalid IP address
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. The IP address being added
did not match any of the configured IP network interfaces.
[IP] x.x.x.x not added to the pool: Invalid Device Id
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. The ID supplied by the IP
subsystem was invalid. Contact your Distributor or Customer Support.
[IP] x.x.x.x not added to the pool: IP Address Pool Full
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. The IP Address Pool was
already full.
[IP] x.x.x.x not added to the pool: Unknown error (y)
A failure was encountered by the IP subsystem during initialization processing. IP made an
unsuccessful attempt to add a “static” address to the IP Address Pool. An unknown error code was
returned by the IP Address Pool Manager. Contact your Distributor or Customer Support.
[IPAP] ResMem returned invalid device maximum value (x)
A memory allocation failure was encountered by the IP Address Pool Manager during initialization
processing. Contact your Distributor or Customer Support.
[IP] Cannot get system memory for xxxx
There is not enough system memory available for IP software to operate (“xxxx” is a variable name
internally used). Contact your Distributor or Customer Support.
Vue de la page 507
1 2 ... 503 504 505 506 507 508 509 510 511 512 513 ... 728 729

Commentaires sur ces manuels

Pas de commentaire