Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 497)

100

101

Central Site Remote Access Switch 497

YSTEM

ESSAGES

System Message Summary

[DHCP-R] Failed to close UDP port (67), erc = <x>

An error occurred while the device was trying to disable the DHCP Relay Agent from Manage

Mode. Contact your Distributor or Customer Support.

[DHCP-R] Failed to open UDP port (67), erc = <x>

An error occurred while attempting to enable the DHCP Relay Agent. The Relay Agent must open

the BOOTPS UDP port in order to operate successfully. If this port could not be opened, the Relay

Agent will not be enabled. Contact your Distributor or Customer Support.

[DHCP-R] Relay Agent disabled

The DHCP Relay Agent has been successfully disabled. This message will appear if the user

disabled the Relay Agent from Manage Mode.

[DHCP-R] Relay Agent enabled

The DHCP Relay Agent has been successfully enabled. This could be during system initialization

(if configuration values have enabled it), or after the DHCP Relay Agent has been enabled from

Manage Mode.

[DHCP-R] Relay Agent initialization failed

This message indicates that the DHCP Relay Agent did not initialize successfully. The Relay Agent

will not be operational. Contact your Distributor or Customer Support.

[DHCP-R] UDP port (67) closed

The DHCP Relay Agent is being disabled from Manage Mode and it must close the BOOTPS UDP

port (port 67). If the DHCP Proxy Client is also enabled, the BOOTPS port must remain open. In

this case, the DHCP Relay Agent will not close the UDP port.

[DHCP-R] UDP port (67) opened

The DHCP Relay Agent is being enabled and it must open the BOOTPS UDP port (port 67). This

may occur during system initialization, or after the DHCP Relay Agent has been enabled from

Manage Mode. If the DHCP Proxy Client is also enabled, it may not be necessary for the Relay

Agent to open this UDP port.

Dial Out Device does not have Bridge Callable Enabled

Check configuration. Enable the Make Calls for Bridge Data field under Device Table Menu, Bridging.

Discrepancy in dynamically-obtained device data

The System authentication type is configured to obtain device information off-node. In an

outbound call scenario with security enabled, two transactions may occur for the same device. If

these do not yield the same information, the call is dropped. Contact your Distributor or Customer

Support.

DL <slot #, port #, ces> Down

The specified data link for a line is down and considered unusable. Refer to the log error messages

for further information (

command).

DM card in slot <slot #> has no firmware

While attempting to initialize the Digital Modem card, the system registered an invalid firmware

state. Contact your distributor or Customer Support. You most likely need to replace or upgrade

the firmware on the Digital Modem.

1 2 ... 492 493 494 495 496 497 498 499 500 501 502 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 497

Commentaires sur ces manuels