Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 494)

100

101

USER’S GUIDE

494 CyberSWITCH

Configured adapter #’x’ type does not exist

The interface adapter indicated does not match the resource configuration in the system. Correct

the configuration on the system.

Connection disconnected for license violation

A connection was disconnected because there were more connections in place than allowed with

your version of the system software. A larger software version should be ordered.

Could not find peer in ip_wan_device_connected

IP reported a new IP stream to RADIUS Accounting, and RADIUS Accounting does not have any

record of this peer. Contact your distributor or Customer Support.

Could not find peer in Stop_accounting_Session

This condition occurs if RADIUS Accounting is enabled while a call is up, and then the call

disconnects. This situation is normal. However, if this occurs at any other time, a problem may

exist. Contact your distributor or Customer Support.

Could not find port for static route with next hop address <AppleTalk Address>

Contact your distributor or Customer Support.

Could not get Call Restriction information

Contact your Distributor or Customer Support.

Could not get current monthly charges information

Could not get the current monthly call charge information on the system. The call charge feature

will be disabled and the problem should be reported. Contact your Distributor or Customer

Support.

Could not obtain fcr packet buffer

AppleTalk related. Contact your distributor or Customer Support.

Couldn’t find speech service - <slot #, port #>

An incoming call was received which specified Speech Bearer Service capability. Speech service is

not currently supported with the System. Most likely, the incoming call was a wrong number. The

system will attempt to treat the call as 56 Kbps data.

CSM at <IP address> is now being used as PRIMARY.

The device at the indicated IP addressed is now acting as a primary CSM service. The primary

service is selected through the CSM GUI. When configuring services, you first add an entry for each

service, then optionally configure managing information to designate primary and secondary

services for the network’s Access Servers.

Current monthly charges reset for new month

Reported on the first day of the month to indicate that the current monthly call charges value is

being reset to zero.

Data link down: Slot=<slot #> Port=<port #> Ces<communication endpoint suffix>

The data link on the specified line is down. If all the data links for a line are down, the line is

disabled for switched connection use.

1 2 ... 489 490 491 492 493 494 495 496 497 498 499 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 494

Commentaires sur ces manuels