Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 460)

100

101

USER’S GUIDE

460 CyberSWITCH

5. A message will be displayed indicating whether or not the call was made successfully. If the

Dial Out call was not completed successfully, try the following:

a. If you issued the

call device <device name>

console command to initiate the call,

check to see that you entered the device name correctly. Device names are case sensitive.

b. If you issued the

call peer <telephone number data rate>

console command to

initiate the call, check to see that you entered the correct telephone number and data rate.

The telephone number must contain all required prefixes such as the area code, or a “9” if

Centrex is used.

c. If you have entered the call device or the call peer command correctly, follow the Set Up

and Action listed below.

Set Up:

• Enable the call trace messages by issuing the

trace on

console command.

• Erase the current system messages (issue the

console command).

• Initiate a call to a remote device by issuing the

call device <device name>

console command.

• Display the system messages (issue the

console command).

• Look for the following call request messages among the system messages.

Out - CALL RQST ACK Call Id=<call Id> Rate=<data rate> Slot=<slot#>

Port=<port#> Chans=<bearer channel map> TN=<telephone number di-

aled> Ces=<communication endpoint suffix> ConnId=<connect Id

In - CALL RQST ACK CallId=<call Id> Slot=<slot#> Port=<port#>

CES=<ces> ConnId=<connection Id>

In - PROCEEDING Call Id=<call Id> Slot=<slot #> Port=<port #>

Chans=<bearer channel map> Ces=<communication endpoint suffix>

ConnId=< connect Id>

In - CONNECT Call Id=<call Id> Slot=<slot#> Port=<port #>

Chans=<bearer channel map> Ces=<communication endpoint suffix>

ConnId=<connect Id>

Action:

• If the system does not report a call request message for the remote device, then the

system did not attempt to make a call. Check to see if there is enough call resources

(lines, channels, supported connections) to make the missing call. For example, if your

system supports only one BRI line, and you have no hunt groups, then only two active

connections are possible. The system would not attempt to make a third call.

If this is not the case, contact Customer Support.

• If the system reports a call request message but it does not connect, then the system

attempted to make a call. Check to see if the remote device has already completed the

installation and verification processes, and is currently running with no active errors.

1 2 ... 455 456 457 458 459 460 461 462 463 464 465 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 460

Commentaires sur ces manuels