Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 442)

100

101

USER’S GUIDE

442 CyberSWITCH

If you see this IP RIP initialization message, the IP RIP has initialized successfully.

3. If the CyberSWITCH does not display the correct IP RIP Initialization message, and instead,

displays one or more of the following messages:

[IP RIP] Initialization failed, unable to allocate buffers

[IP RIP] Unable to open RIP/UDP port 512

There may be an a problem within the software. Contact Customer Support.

IP RIP OUTPUT PROCESSING ON A LAN INTERFACE

To verify that IP RIP Output Processing (routes advertisement) is properly operational on a LAN

interface, the IP RIP processing must be successfully initialized. Also, a local IP host (router) must

be connected to the local LAN port on the system and capable of learning routes information via

RIP.

Below is an example of a configuration used to verify IP RIP output processing on a LAN interface.

It uses IP addresses specific to the example. Substitute the IP addresses of your network when you

perform the verification steps. It also uses the

netstat

administration console command. The

netstat

command displays the IP routing table of the system. Substitute the equivalent command

on your IP host.

1. Make sure that a static route to the network 192.1.1.0 is configured on SITE1. On SITE1’s

administration console type:

ip route

If the route to 192.1.1.0 is displayed continue with step 3.

2. If the route is NOT displayed, use the Manage Mode command

iproute add

to add the

static route.

"SITE1"

"SITE2"

100.0.0.1

ISDN

Host A

100.0.0.2

LAN 192.1.1.0

CSX5500 CSX5500

1 2 ... 437 438 439 440 441 442 443 444 445 446 447 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 442

Commentaires sur ces manuels