Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 437)

100

101

Central Site Remote Access Switch 437

ERIFYING

OUTING

ROTOCOLS

IP Routing Operational?

1. Determine if a remote IP host can access the CyberSWITCH over the WAN connection. On the

remote IP host type:

ping 100.0.0.1

If the remote IP host successfully pings to the CyberSWITCH, continue with the step 3.

2. If the remote IP host CANNOT ping to the CyberSWITCH, try the following:

a. Verify that the WAN connection is up. Use the

console command to check for the

connection. If the connection is NOT up, refer to Remote Device Connectivity.

b. Verify that the WAN (Direct Host) interface is properly initialized. Use the

ipnetif

command (a Manage Mode command) to check for the proper WAN (Direct Host)

interface. If the interface does NOT exist, use CFGEDIT to make corrections

c. Verify that the subnet mask information and the IP address for the Remote Host matches

the IP Host configuration.

3. Determine if a remote IP host can access the local IP host through the CyberSWITCH over the

WAN connection. On the remote IP host type:

ping 100.0.0.2

If the remote IP host successfully pings to the local IP host, then IP routing over WAN (Direct

Host) interface is operational. Repeat the above steps for each WAN (Direct Host) interface you

wish to access.

4. If the remote IP host CANNOT ping to the local IP host, try the following:

Verify that the remote IP Host can access the LAN interface of the CyberSWITCH, since the

remote IP Host connected to a WAN (Direct Host) interface should be recognized as if it were

located on the local Ethernet. Refer to the Verifying IP Routing Over a LAN Interface section for

more information.

100.0.0.1

100.0.0.0

Host A

100.0.0.2

Host B

100.0.0.3

ISDN

CSX5500

1 2 ... 432 433 434 435 436 437 438 439 440 441 442 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 437

Commentaires sur ces manuels