Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 386)

100

101

USER’S GUIDE

386 CyberSWITCH

3. The current status D Channel Callback will be displayed. Select 1 to toggle from disabled to

enabled (as shown by the following screen).

Note: In addition to the CFGEDIT configuration changes, you must also do some configuration

through CSM for callback to work. You must define the calling device on CSM. For each

configured calling device make sure to:

• Configure a calling line ID for the number the device will be using when calling into

the CyberSWITCH (located under the device’s Telephone tab).

• Configure the telephone number to be used to call back to the calling device (located

under the device’s Telephone tab). This number is often the same as the CLID or

possibly with a preceding 9 if under Centrex.

• Enable the Callback option (located under the device’s Access/Other tab).

• Enable Outbound Authentication if you want to make sure the device you are calling

back to is the correct device (located under the device’s Access/Authentication tab).

For more detailed instructions, refer to the CSM user documentation.

SING MANAGE MODE COMMANDS

There are no associated Manage Mode commands.

D CHANNEL CALLBACK CONFIGURATION ELEMENTS

CALLBACK STATUS

You may select to enable or disable the callback feature for devices using CSM for authentication.

D CHANNEL CALLBACK BACKGROUND INFORMATION

When an incoming ISDN call is presented to the CyberSWITCH, certain information is presented

on the D Channel including the callers telephone number. Rather than accept the call right away,

the CyberSWITCH uses the calling line ID (CLID) to send a request to CSM to do a lookup based

on this CLID (as noted earlier, this option is only available if you are using CSM for device level

authentication). If CSM can find a device which has a matching CLID configured and that device

has callback enabled, we will reject the call being presented and wait for CSM to issue a call request

to the device previously identified. If callback is NOT enabled in CSM for this device or NO device

could be identified by this CLID, we will allow the call presented to be accepted and will proceed

to the authentication phase using PAP/CHAP/ etc. as usual.

D Channel Callback Menu:

Current Settings

1) D Channel Callback (Enable/Disable) Enabled

Select function from above or <RET> for previous menu:

1 2 ... 381 382 383 384 385 386 387 388 389 390 391 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 386

Commentaires sur ces manuels