Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 375)

100

101

Central Site Remote Access Switch 375

ONFIGURING

ALL

ONTROL

Call Restrictions

Two actions are available if this limit is exceeded. These actions are:

1. The call will not be allowed; a message will be displayed on the LCD, and written to the report

log.

2. The call will be allowed; however, a warning will be displayed on the LCD, and written to the

report log.

Note: Existing calls will not be disconnected when this limit is reached. Subsequent calls may not

be allowed, but existing calls will be allowed to continue.

AXIMUM CALL MINUTES PER MONTH

The maximum number of call minutes per month. The default value is 5520 call minutes per month.

Call minutes will be calculated periodically while calls are active (not when a call is disconnected).

Statistics will be kept to track the total number of call minutes made per month. This statistic will

be written to the statistics log every half hour, and available through the

command. The current

value of this statistic will be displayed on the LCD, and will also be displayed on the monitor when

the

cr stats

command is used.

Two actions are available if this limit is exceeded. These actions are:

1. The call will not be allowed; a message will displayed on the LCD, and be written to the report

log.

2. The call will be allowed; however, a warning will be displayed on the LCD, and written to the

report log.

Note: Existing calls will not be disconnected when this limit is reached. Subsequent calls may not

be allowed, but existing calls will be allowed to continue.

AXIMUM CALL LENGTH

The maximum amount of time (in minutes) that a call is allowed to be active. The default value is

240 minutes.

Note: The system checks for violation of configured maximum call length every five minutes. So,

for example, if you set the maximum call length to one minute, there will be a five minute

window around that one minute in which the system will check for a violation.

Two actions are available if a call exceeds this limit. These actions are:

1. The call is disconnected; a message will be displayed on the LCD, and written to the report log.

2. The call is continued; however, a warning will be displayed on the LCD, and written to the

report log.

UDIBLE ALARM STATUS

The audible alarm can be enabled or disabled. This alarm is used to signal you when a call

restriction has been violated. The alarm is a series of beeps, that are repeated every 5 minutes while

any call restriction is in violation.

1 2 ... 370 371 372 373 374 375 376 377 378 379 380 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 375

Commentaires sur ces manuels