Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 252)

100

101

USER’S GUIDE

252 CyberSWITCH

X.25 RESTRICTION FACILITIES

These facilities are used to place restrictions upon incoming and outgoing X.25 calls.

ARRING INCOMING CALLS

Allows to you bar X.25 calls coming in to the system. The default configuration is to not bar

incoming X.25 calls.

ARRING OUTGOING CALLS

Allows you to bar X.25 calls going out of the system. The default configuration is to not bar

outgoing X.25 calls.

X.25 M

ISCELLANEOUS FACILITIES

These facilities are used for fast select acceptance for incoming and outgoing X.25 calls. Fast select

is a calling method that allows the device to send a limited amount of information along with a “call

request packet” rather than after the packet.

AST SELECT ACCEPTANCE - INCOMING CALLS

Allows you to chose whether fast select acceptance should be done on incoming calls. The

default configuration is to not perform fast select acceptance on incoming calls.

AST SELECT ACCEPTANCE - OUTGOING CALLS

Allows you to chose whether fast select acceptance should be done on outgoing calls. The

default configuration is to not perform fast select acceptance on outgoing calls.

After all of the above X.25 facilities have been specified, the configuration of the X.25 access itself

have been completed. You may now configure the virtual circuits associated with the X.25 access.

PVC C

ONFIGURATION ELEMENTS

Once the above X.25 configuration elements have been configured, the associated virtual circuits

should be configured. Note that virtual circuits may be configured with any combination of SVCs

and PVCs, adding up to a maximum of 48 virtual circuits.

A PVC is similar to a dedicated line. At subscription time, the subscriber gives the network the

address to be associated with that virtual circuit. A logical channel is permanently assigned. From

that point on, no call set up is needed. Data to be sent to that destination are simply sent in data

packets using the assigned logical channel.

OGICAL CHANNEL NUMBER (LCN)

X.25 uses LCNs to distinguish the connections between DTEs at either end of a communication.

These LCNs make it possible to send a packet into a packet-switched network at one end (with no

control over the packet’s journey) and then to pick the packet out at the receiving end. LCN values

for PVCs are obtained from the PPSN carrier.

ONSTANDARD DEFAULT TRANSMIT WINDOW SIZE

The number of frames that a DTE can send without receiving an acknowledgment. Using modulo

128, the DTEs can send up to 127 frames without receiving an acknowledgment. Using modulo 8,

the DTEs can send up to 7 frames without receiving an acknowledgment. The default value for both

modulo 8 and modulo 128 is 2.

1 2 ... 247 248 249 250 251 252 253 254 255 256 257 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 252

Commentaires sur ces manuels