Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 198)

100

101

USER’S GUIDE

198 CyberSWITCH

BRIDGE INFORMATION CONFIGURATION ELEMENTS

IP (SUB) NETWORK NUMBER

If the CyberSWITCH uses an IP RLAN interface to connect to a remote bridge, you must provide

this information.

This address associates the bridge with the IP network to which it connects. Enter this address

using dotted decimal notation. This parameter applies to the network-portion of the IP address

only. Note that if you change the IP address under the IP information menu selection, this parameter

will reflect that change.

NABLE/DISABLE BRIDGING

You may enable or disable bridging on a per device basis. You must enable bridging for remote

LAN devices, which indicates that the remote device is a bridge and not a router.

AKE CALLS FOR BRIDGE DATA

You must enable this element to allow bridge dial out to function. You must also complete the

following configuration:

• Enable bridging at the system level and at the per-device level.

• Either add the device to the CyberSWITCH’s Known Connect List, or configure a bridge con-

nection filter. For information regarding the Known Connect List, refer to page 285. For infor-

mation regarding bridge filters, refer to page 269.

Note: This feature is not yet supported for IPX Remote LANs.

IPX R

EMOTE LAN NETWORK NUMBER

If the CyberSWITCH uses an IPX RLAN interface to connect to a remote bridge, you may choose to

change this information.

This parameter associates the bridge with the IPX network to which it connects. Enter the IPX

external network number of the remote LAN, or accept the default value of none.

If this parameter remains none, the CyberSWITCH will assume the network number is that of the

first configured IPX Remote LAN interface. This is convenient in applications in which remote

LANs consist only of clients (thus no explicit external network address), all of which are on the

same external virtual LAN.

If you choose to change this parameter, you must specify the IPX external network number used

on the remote LAN in question. This value must be the same as the value configured for the

corresponding IPX Remote LAN interface.

IPX S

POOFING OPTIONS

Note: This feature is not yet supported for IPX Remote LANs. Do not attempt to configure.

PPLETALK NETWORK NUMBER

If the CyberSWITCH uses an AppleTalk WAN (Remote LAN) port to connect to a remote bridge,

you may choose to change this information.

This parameter associates the bridge with the AppleTalk network to which it connects. Enter the

AppleTalk network number/range (which corresponds to a configured AppleTalk Remote LAN

port), or accept the default value of none. If this parameter remains none, the CyberSWITCH will

assume an association with the first configured AppleTalk Remote LAN port.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 198

Commentaires sur ces manuels