Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 196)

100

101

USER’S GUIDE

196 CyberSWITCH

compare the incoming CLID with the value configured in the On-node Device Table. If the

numbers are identical the connection will be established. Otherwise, the system will reject the

incoming call.

When two remote devices share the same line (a single point-multipoint ISDN line), they can also

configure the same CLIDs if they both also have some other type of authentication configured (for

example, PAP, CHAP, or Bridge MAC Address Authentication).

Note: If a system is brought on line with a device that has a required CLID that is a duplicate of

another device’s CLID, and no other type of authentication is used, a warning message is

logged at initialization.So every attempt to connect the device thereafter will result in an

error message being logged and the call being rejected.

IP I

NFORMATION CONFIGURATION ELEMENTS

IP ADDRESS

The device’s IP address, if any, on the WAN link connecting it to the CyberSWITCH. Options are:

none (for Direct Host or WAN links that plan to use dynamic address allocation), 0.0.0.0 (for

unnumbered WAN links), or an explicitly defined IP address.

The system must have a valid IP Network Interface defined for this IP address. When IP dial-out is

used, this address is required by the IP routing system in order to map the IP address to the phone

number to be dialed.

NABLE/DISABLE IP ROUTING

You may enable or disable IP routing on a per-device basis.

NABLE/DISABLE MAKE CALLS FOR IP DATA

This element must be enabled to allow IP dial-out to function. At least one Dial-Out phone number

or X.121 address is required to dial out.

IPX I

NFORMATION CONFIGURATION ELEMENTS

IPX ROUTING

You may enable or disable IPX on a per-device basis.

AKE CALLS FOR IPX DATA

Indicates whether the system should establish a WAN connection in order to forward IPX

datagrams to this remote device. If enabled, at least one Dial-Out phone number or X.25 VC name

is required.

IPXWAN

PROTOCOL

Indicates that the remote device is an IPX router and that the IPXWAN protocol must immediately

succeed IPXCP negotiations. Provides interoperability with Novell products.

IPX

ROUTING PROTOCOL

Indicates the protocol the remote device will be using to communicate with the CSX system:

•none

• RIP/SAP

• triggered RIP/SAP

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 196

Commentaires sur ces manuels