Enterasys Networks CSX7000 Manuel d'utilisateur Page 180

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 179
USER’S GUIDE
180 CyberSWITCH
4. You may specify an authentication database location for administrative sessions that is
different from the user authentication database location.
Note: If you select RADIUS, TACACS, or ACE, you must be sure that the selected server is
active before you initiate an administrative session.
5. From the Administrative Session menu select (2) Session Inactivity Timeout. The following
prompt is displayed:
6. Follow the onscreen instructions to set the session inactivity timeout session.
7. From the Administrative Session menu, select (3) Number of Admin Telnet Sessions. The
following prompt is displayed:
8. Follow the onscreen instructions to configure the number of administrative Telnet sessions you
wish to allow. Up to three sessions are possible.
Note: To have any Telnet sessions, you must first enable IP.
9. To change the value of the port number, select (4) Telnet Server TCP Port Number from the from
the Administrative Session menu.
10. Follow the onscreen instructions for entering the port number.
11. Select option (5) Emergency Telnet Server Port Number from the Administrative Session menu.
12. Follow the onscreen prompts to configure the port number.
U
SING MANAGE MODE
admlogin
Displays the current administration session configuration.
admlogin change
Displays the Administration Session Configuration Menu screen, allowing you to change the
authentication database location. Refer to Using CFGEDIT for configuration instructions.
ADMINISTRATIVE SESSION CONFIGURATION ELEMENTS
DATABASE LOCATION
The authentication database location for administration sessions. This database location may be
different from the user authentication database. The default database location is the on-node device
database.
Enter the Session Inactivity Timeout value in minutes.
Use "0" to disable the Session Inactivity Timeout [default = disabled]?
Enter the number of Telnet allowed for administrative sessions.
Use "0" to disable the Telnet Server [default = 3]? 1
Vue de la page 179
1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 728 729

Commentaires sur ces manuels

Pas de commentaire