Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 156)

100

101

USER’S GUIDE

156 CyberSWITCH

STATIC ROUTE BACKGROUND INFORMATION

You only need to configure Static Routing entries if you need to access a WAN network that is not

directly connected to the system, or if you need to access a LAN network through a router that does

not support IP RIP. Static Routes specify the IP address of the next hop router or gateway that

provides access to this network.

The following diagram gives an example of a static route definition.

In the above diagram, the Static Route entry indicates that access to IP Network 156.1.0.0 is

available through the external router at 192.1.1.2.

A static route is not needed for the CyberSWITCH to access WAN Direct Host 128.1.1.3. Because

these two devices are directly connected, (note that the IP addresses are on the same subnet), that

route will automatically be established through the system’s IP RIP capabilities.

A static route is not needed for system access to IP network 131.1.0.0 through 128.1.1.2 because that

route will also be automatically established through the system’s IP RIP capabilities.

ISDN

Host

156.1.0.0

Router

192.1.1.2

128.1.1.3

WAN Direct Host

Interface

WAN Interface

192.1.1.1

128.1.1.1

128.1.1.2

131.1.0.0

Router

Static Route

IP Address 156.1.0.0

Next Hop 192.1.1.2

LAN Interface

CSX5500

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 156

Commentaires sur ces manuels