Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 155)

100

101

Central Site Remote Access Switch 155

ONFIGURING

ASIC

IP R

OUTING

Static Routes

reachable directly and therefore no intermediate router will be used. The default metric value is 2.

The range of metric values for static routes is from 0 to 15.

You may manipulate the metric value to promote a certain default route, or to impede a default

route from being used. For example, if there is a route that in reality has several hops, but they are

all over LAN connections, you may want to assign a low metric to this route so that a route is taken

that is local, thus, no toll charges. Or, perhaps there is a route with a low number of hops, but the

connection is over a WAN. You may want to assign this route a high number of hops to limit toll

charges, in case there is a local route that could be used.

IP RIP P

ROPAGATION CONTROL

This controls how a static route is propagated via IP RIP. The following table provides an

explanation of how a IP RIP propagation control flag can be assigned to a static route.

Flag Meaning

Propagate Always This flag indicates that the route information is

always propagated via IP RIP.

This flag is available when the next hop is over a

LAN or a WAN interface.

Propagate only when the

Next Hop is Connected

This flag indicates that the route information is

propagated via IP RIP only when the next hop router

is connected to the system.

This flag is available when the next hop is over a

LAN or a WAN interface.

Do Not Propagate This flag indicates that the static route information is

not propagated over the interface.

This flag is available only when the next hop is over

a WAN interface.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 155

Commentaires sur ces manuels