Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 141)

100

101

Central Site Remote Access Switch 141

ONFIGURING

ASIC

IP R

OUTING

IP Network Interfaces

An IP Host device has only one network interface that it uses for data transfer. This network

interface is assigned an IP address and belongs to one subnet. A remote IP host typically uses an

ISDN line for this network interface. All data is sent through this network interface.

An IP router device can have multiple network interfaces. Each of these are assigned an IP address

and belong to a separate subnet. The IP router looks at the IP network information in a packet and

uses this to decide to which network interface the packet should be forwarded.

The CyberSWITCH provides a set of network interfaces that give you a wide range of flexibility.

The network interfaces provided are:

• LAN IP Network Interface

• WAN IP Network Interface

• WAN (Direct Host) IP Network Interface

• WAN (RLAN) IP Network Interface

• WAN (UnNumbered) IP Network Interface

With IP routing enabled, you must specify each network interface and its associated subnet

information. This allows the System to route IP data between network interfaces. In this mode, IP

Hosts and IP routers can connect to the system. Even MAC layer bridge devices can connect to the

system and use IP protocols through a IP RLAN Network Interface.

With the LAN, WAN and WAN(RLAN) IP interfaces, you may enable the Routing Information

Protocol (RIP). If RIP is enabled (automatically enabled with new installs; not enabled in upgrades),

there will be extra information required for configuring LAN type interfaces (LAN and RLAN

interfaces) and WAN interfaces. This is because IP RIP uses these types of interfaces to propagate

IP RIP packets. For further information, refer to the section IP RIP and the IP Network Interfaces.

The following table provides the IP Network Interfaces and the associated remote devices that use

these interfaces.

The LAN IP Network Interface is used to define the subnet information for an Ethernet port. This

subnet is usually connected to the central IP network. You must configure a LAN IP Network

Interface if you have any devices that need to communicate over the local network. You may

optionally configure additional secondary LAN IP network interfaces on the same LAN port.

Refer to Network Flattening for more information.

IP Network Interface Type Associated Remote Device

WAN IP Host (RFC1294)

PPP

WAN (Direct Host) IP Host (RFC1294)

PPP

WAN (RLAN) HDLC Bridge

PPP

WAN UnNumbered PPP

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 141

Commentaires sur ces manuels