Enterasys Networks G3G124-24 Manuel d'utilisateur télécharger pdf (Page 43)

Installing an Optional PoE Module in the G3G124-24 Switch

Enterasys G-Series Hardware Installation Guide 2-21

c. FordetailsonhowtoconfiguretheG‐Seriesusingthecommandlineinterface,refertothe

EnterasysG‐SeriesCLIReference.TheCLIcommandsenableyoutosetanewpassword

andperformmoreinvolvedmanagementconfigurationsontheG‐Series.

Ifyourequireassistance,contactEnterasysNetworksusing

oneofthemethodsdescribedin

“GettingHelp”onpage xv.

Installing an Optional PoE Module in the G3G124-24 Switch

InstallingPoEcapabilityintheG3G124‐24baseswitchrequiressignificantdisassemblyofthe

switch.BeforeinstallingthePoEmodule,youmustcompletethefollowingsteps:

1. Unplugallpowerandnetworkconnectionstotheswitch.

2. RemoveIOMmodule(s).Referto“RemovinganIOM”onpage 2‐11.

3. Removepowersupplies.Referto

“RemovingaPowerSupply”onpage 2‐8.

4. Removeandretainscrewssecuringtheswitchcovertopandcompactflashcoverplateand

removetheswitchcover.Referto“RemovingtheSwitchCover”onpage 2 ‐21.

Removing the Switch Cover

IfyouhavepurchasedanoptionalPoEmodule(G3G‐POE),haveunpluggedallnetworkand

powerconnectionsandremovedpowersupplies,youmustremovetheswitchcoverasfollowsto

accessthePoEboardconnectorsintheG‐Seriesbasechassis.

1. RefertoFigure 2‐12tolocateallscrewsnecessaryfor 

removingthecover.

Note: It is strongly recommended that you change the admin password from its default state of

blank (no password), once the G-Series switch becomes operational in your network. For more

information, refer to the Enterasys G-Series CLI Reference

Note: Instructions for installing PoE on the base switch do not apply to the G3G124-24P model

since it is already equipped with a PoE card.

Caution: Be sure to retain all screws removed from the G-Series switch cover in a secure location

to avoid misplacing them. Leaving any loose screws inside the switch could result in severe

damage to switch components.

Precaución: Asegúrese de colocar todos los tornillos que haya retirado de la cubierta del switch G-

Series en un lugar seguro, para evitar perderlos. Cualquier tornillo suelto que se deje en el interior

del switch podría dañar sus componentes.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 58 59

Pas de commentaire

Enterasys Networks G3G124-24 Manuel d'utilisateur Page 43