Enterasys Networks G3G124-24 Manuel d'utilisateur Page 40

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 59
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 39
Connecting to the Network
2-18 Installation
ToinstallaSFP/XFP,refertoFigure 210andproceedasfollows.
1. Withanantistaticwriststrapattachedtoyourwrist,removethetransceiverfromits
packaging.Ifthereisaprotectivedustcoverinthetransceiverconnector,donotremoveitat
thistime.
2. Holdthetransceiversothatthe
connectorwillseatproperly.
3. CarefullyalignthetransceiverwiththeportslotasshowninFigure 210.
4. Pushthetransceiverintotheportslotuntilit“clicks”andlocksintoplace.
Figure 2-10 Installing an SFP/XFP (shown with LC connector and without dust cover)
Caution: Carefully follow the instructions in this manual to avoid damaging the SFP/XFP and
G-Series.
The SFP/XFP and G-Series are sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to do so could result in damage to the
SFP/XFP and G-Series. Always leave the SFP/XFP in the antistatic bag or an equivalent antistatic
container when not installed.
Precaución: Siga las instrucciones del manual para no dañar el SFP/XFP ni del aparato, puesto
que son muy sensible a las descargas de electricidad estática. Utilice la pulsera antiestática y tome
todas las precauciones necesarias durante este procedimiento. Si no lo hace, podría dañar el SFP/
XFP o del aparato. Mientras no esté instalado, mantenga el SFP/XFP en su bolsa antiestática o en
cualquier otro recipiente antiestático.
1 Release tab 4 Edge connector (insertion side)
2 Wire handle 5 Port slot
3 Transceiver top side 6 Transceiver side view
Vue de la page 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 58 59

Commentaires sur ces manuels

Pas de commentaire