Enterasys Networks G3G124-24 Manuel d'utilisateur Page 33

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 59
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 32
Installing and Removing an IOM
Enterasys G-Series Hardware Installation Guide 2-11
Figure 2-4 Installing an IOM (G3G-24TX with optional PoE shown)
7. Toinstalladditionalmodules,removethecoverplatesfromtheslotsandrepeatearliersteps.
Savecoverplatesforoptionalfutureuse.
8. Aftercompletingallmoduleinstallation,besuretoinstallcoverplate(s)overanyunusedIOM
slot(s)tocontainEMIradiationandensureproperaircirculation.
Removing an IOM
ToremoveaninstalledIOM,firstdisconnectanycablingandperformthesesteps:
1. Loosenthemodule’stwocaptivescrews.
2. PressthePOWEROFFbuttoncorrespondingtotheslotfromwhichyouwanttoremovethe
IOM.RefertoFigure 31onpage 32formoreinformation.
3. Whentheslot’sPOWEROFFstatus
LEDturnsamber,gentlyslidethemoduleoutoftheslot.
Formoreinformation,referto“IOMStatusLEDsonpage 33
.
1 IOM slot 2 4 Optional PoE module
2 IOM handle 5 IOM module
3 Captive screw
Note: You must reboot the system before hot-inserted IOM modules will be recognized. Once
rebooted, module LEDs will display as described in “IOM Status LEDs” on page 3-3.
Caution: Do not attempt to remove an IOM module from the G-Series switch when power is on to
the switch without performing the following procedure.
Precaución: No intente retirar el módulo IOM del switch G Series si éste está encendido. Antes de
hacerlo, debe realizar el siguiente procedimiento.
Vue de la page 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 58 59

Commentaires sur ces manuels

Pas de commentaire