Enterasys Networks RBT-8200 Manuel d'utilisateur télécharger pdf (Page 18)

Chassis Back I/O Ports and Features

1-4 RBT-8200 Wireless Switch Setup

Chassis Back I/O Ports and Features

Figure 1‐2showsthebackI/OPortsandfeaturesfortheRBT‐8200WirelessSwitch.

Figure 1-2 Back I/O Ports and Features

Power Supply

250 Watt Power Supply

The250wattpowersupplyisratedfor250wattsofpoweratthefollowingvoltagesandisratedas

follows:

• 100–127voltsat50/60Hz;5Amaximum

• 200–240voltsat50/60Hz;2.5Amaximum

A. Not supported

B. Not supported

C. RJ45 Serial B

D. NIC 1, NIC 2 connector

E. Not supported

F. Not supported

G.Not supported

H.Not supported

I. Not supported

J. Not supported

K. Not supported

L.AC Power Connector

M. Not supported

Warning: Do not attempt to modify or use the supplied AC power cord if it is not the exact type

required.

The power supply cord is the main disconnect to AC power. The socket outlet must be installed

near the equipment and readily accessible.

If the power cord supplied with the system is not compatible with the AC wall outlet in your region,

get one that meets the following criteria:

• The cord must be rated for the available AC voltage and have a current rating that is at least

125 percent of the current rating of the server.

• The plug on the power cord that plugs into the wall outlet must be a grounding-type male plug

designed for use in your region. It must have certification marks showing certification by an

agency acceptable in your region.

• The connector that plugs into the AC receptacle on the power supply must be an IEC 320, sheet

C13–type female connector.

• In Europe, the cord must be less than 4.5 meters (14.76 feet) long, and it must be flexible <HAR>

(harmonized) or VDE certified cordage to comply with the chassis’ safety certifications.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Pas de commentaire

Enterasys Networks RBT-8200 Manuel d'utilisateur Page 18